[product name] disposable sterile cotton sheet

[specification and model] type I and type II; length (10 mm-150 mm) × width (10 mm-150 mm). See small package for specific specifications.

[name of registrant] Henan Jianqi medical device Co., Ltd

[residence] dingluan Industrial Zone, Changyuan County

[Tel.] 0373-8690789

[after sales service unit] Henan Jianqi medical equipment sales Co., Ltd

[name of manufacturer] Henan Jianqi Medical Equipment Co., Ltd

[residence] dingluan Industrial Zone, Changyuan County

[production address] dingluan Industrial Zone, Changyuan County

[contact information] 0373-8690789

[production license] ysyjx production license No. 20080036

[Registration Certificate No.] yxzz 20162640345

[product technical requirements No.] yxzz 20162640345

It is mainly composed of cotton and cotton.

[product performance] 1. The cotton sheet should be white and soft fiber without stain, stain and foreign matter, and there should be no burr or loose cotton wadding around. 2. The specification of medical absorbent cotton is not less than 80g / m2, and its water absorption performance should meet the requirements of yy0330-2006. 3. The length of polyester yarn is 40 cm ± 2 cm. 4. The length of x-ray detectable line is 22cm ± 2cm. 5. The residual content of ethylene oxide should be no more than 10ug / g. 6. The product should be sterile.

[scope of application] it is used for clinical wound protection and moisture absorption.

[contraindications] no contraindications.

[precautions] 1. This product is disposable and its package is damaged. It is forbidden to use it and destroy it after use.

2. The batch number and date of production are shown in the seal or certificate, and the sterilization date is shown in the outer packing box.

3. The product was sterilized by ethylene oxide.

[usage] 1. Select the appropriate product size and open the package after confirming that the outer package is in good condition.

2. Or with the aid of medical tweezers, the cotton piece is put into the position where hemostasis or aspiration is needed.

3. Leave the polyester thread (or x-ray detectable wire) outside the skull for removal after use.

4. If the polyester thread or x-ray detectable line is brought into the skull, the head shall be fluoroscopically examined immediately. If the developing line is found, the position of the cotton piece can be confirmed. (this method is only effective for cotton chips with x-ray detectable lines.)

4. After the end of use, the product should be treated as medical waste to avoid pollution.

[storage method] 1. The product should be loaded and transported in covered carriage and cabin, and kept clean. It should not be under heavy pressure, direct sunlight, rain or snow.

2. Handle with care to avoid violent collision;

3. The product should be stored away from the fire source, the relative humidity is not more than 80%, no corrosive gas and well ventilated and clean environment.